Thermal Detonator Electronics Kit V1.0. 

This Thermal Detonator Electronics Kit is available as a self build or a pre-built kit.

The Self Build Kit requires the main components and sockets to be soldered to the PCB as well as  soldering leads to the other components to plug into the PCB, so is really only suitable for those with soldering and electronics skills.

The Pre-Built Kit does NOT require any Soldering, all components are soldered and pre wired ready to install in your 3d Printed Class-A Thermal Detonator. You just need to plug the components into the PCB.

If you have a UK Shipping address you have the option to add the battery to the kit.

Arduino Code:

The Arduino Code for the Seeeduino XIAO can be Downloaded from my GitHub Page

STL Files:

The STL Files are available to Download form my GitHub Page

Alternatively you can download Oubliette's Class-A Thermal Detonator STL files form Thingiverse

The Kit Includes the Following Components:

• TDTroniX PCB Board with all resistors pre-soldered
• Seeeduino XIAO Micro Controller pre-programmed with the Thermal Detonator V1.0 code
• DFPlayer Mini MP3 Player 
• 4GB Micro SD-Card
• PAM8403 Amplifier
• 2W 8Ohm 28mm Flat Speaker
• 5mm Red LED 
• 5mm Red LED Holder
• 3 x 3mm Yellow LED's 
• 3 x 3mm Metal LED Holders
• Mini Lever Switch
• 7 x 2 Pin JST-PH 2.0 Sockets & Leads
• Tilt Sensor
• Pin Headers for Seeeduino XIAO, DFPlayer Mini & PAM8403 Amplifier

Please Note: The kits DO NOT includes a battery.

Due to international postal restrictions regarding the shipping batteries I am unable to send them in the kits for buyers outside the UK.

I recommend using a 3.7V 650mAh battery (As used in the Syma X5C) and measures approximately 43.5cm Long x 24.5cm Wide x 8cm Deep

These are readily available on AliExpress, eBay and Amazon.

Both kits come supplied with the JST PH 2.0 connector lead for the battery. You need to solder this lead to your battery so you can plug it into the TDTroniX PCB.

UK BUYERS ONLY

UK buyers with a UK shipping address have the option to add a Battery to their order.

Just Select - Add a 1S 3.7V 220mAh 35C Battery - The battery will come supplied with the correct lead to plug straight into the PCB.

Package Includes:

• 1 x Thermal Detonator V1.0 Electronics Kit - Self Build or Pre-Built Kit

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy.