Blaster Scope Electronics Kit. 

Self build electronics kit for an animated Blaster Scope Display.

The kit comprises the following components:

• 1 x DFRobot Beetle - Pre Programmed with the Scope Code
• 1 x 0.49" OLED Display
• 1 x Red Dot LED Laser Diode
• 1 x 2-Pin Micro JST Connector Set - Laser LED Power
• 2 x 3-Pin Micro JST Connector Sets - 2 Switches Scope Change and Laser On/Off
• 1 x 4-Pin Micro JST Connector Set - OLED Display
• 1 x 2-Pin JST PH2.0 Male and Female Lead for Battery Power
• 2 x 10K Resistors - for the 2 Switches
• 2 x 6 x 6 x 6mm Tactile Momentary Switch (Scope Change and Laser On/Off)

Don't forget to add the following products to your order:

E-11 Blaster Scope STL Files:

These STL Files were designed by me especially for my E-11 Blaster Electronics.

E-11 Blaster Scope Hardware Kit:

3 x Cheesehead Screws used in the front of the Scope, 2 Neodymium Magnets to hold the Electronics Holder in the Scope, 30mm Round Glass Lens and a Red Acrylic Film for the Lens.

Please Note:

The Hardware Kit is included in the E-11 Stormtrooper Blaster Rifle Hardware Kit and the STL Files are included in the E-11 Stormtrooper Blaster Rifle STL Files.

So you only need to purchase this kit if you are just buying just the E-11 Blaster Scope STL Files.

Please Note: This  Blaster Scope Electronics Kit does NOT includes a Battery.

The power is supplied directly from the battery you use in your Blaster.

Package Includes:

• 1 x SCTroniX Blaster Scope Self Build Electronics Kit.

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy.