NN-14 Blaster Pistol Electronics Kit.  

Self Build or Pre Built Electronics Kit for the NN-14 Blaster Pistol from "The Force Awakens".

This kit is available as either a self build or as a pre-built electronics kit for the NN-14 Blaster Pistol STL Files as seen in "The Force Awakens". 

Self Build Kit - Some soldering is required to solder the JST leads to the Switches, Speaker, Red Dot Laser, OLED Display and Neopixels. 

Pre-Built Kit - All components pre wired ready for install into the NN-14 Blaster.

I recommend using 30awg silicone wire for connecting all switches as this wire is thin and very flexible.

The kit comprises the following components:

• 1 x NN-14 PCB Board with all resistors, headers and sockets pre-soldered.
• 1 x Arduino Nano (or compatible) Micro Controller pre-programmed with the NN-14 Blaster Pistol code
• 1 x DFPlayer Mini MP3 Player 
• 1 x PAM8403 Amplifier
• 1 x Micro SD-Card with Sounds Pre-Loaded
• 1 x 3W 4 Ohm Speaker with Lead
• 2 x 6mm x 7mm Tactile Switches (Trigger & Red Dot Laser On/Off)
• 2 x 6mm x 4mm Tactile Switches (Weapon Select & Weapon Reload)
• 1 x Red Dot Laser Diode LED
• 1 x Single WS2812B LED (Fire LED)
• 2 x WS2912B LED Strip (Barrel LED's)
• 7 x 2 Pin JST PH-2.0 Leads & Sockets - (Select, Reload, Trigger, Laser LED On/Off, Laser LED Power, Speaker & Battery)
• 1 x 3 Pin JST PH-2.0 Lead & Socket - LED Strip
• 1 x 4 Pin JST PH-2.0 Lead & Socket - OLED Display
• 1 x Mini Slide Switch (Power On/Off)
• TP4056 Battery Charge Board (For Charging the Battery)
• 1 x PropTroniX 18650 Battery Holder  - For the Battery
• 1 x 0.66" OLED Display (Optional)

Don't forget to add the following products to your order:

NN-14 Blaster Pistol STL Files:

These STL Files were designed by me especially for my NN-14 Blaster Pistol Electronics - Available on my STL Site

NN-14 Blaster Pistol STL Hardware Kit:

The NN-14 Blaster Pistol STL Hardware kit includes all the screws, magnets and springs used in the build.

Please Note: The kit does NOT include a battery. 

Due to international postal restrictions regarding the shipping batteries I am unable to include them in the kits for buyers outside the UK.

I recommend using a 3.7V 18650 battery, 

These are readily available on eBay and Amazon.

Very Important Notice:

Please make sure you double check the polarity of all connections before attaching any power.

A kit without the PCB Board will include all the required resistors - (This option is ideal if you wish to install the Arduino Nano, DFPlayer Mini and PAM8403 Amplifier id different parts of the Blaster)

Package Includes:

• 1 x NN-14 Blaster Pistol Electronics Kit. (Self Build or Pre Built)

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy.