Arduino Nano V3.0 + BLTroniX Blaster Code

Arduino Nano V3.0 pre programmed with the BLTroniX Blaster Code.

Note: The Arduino Nano V3 may be supplied either with unsoldered or pre-soldered pins depending on stock availability.

Options:

• Arduino Nano V3.0 pre-programmed with BLTroniX V2.0 E-11 Blaster Code..
• Arduino Nano V3.0 pre-programmed with BLTroniX V2.0 F-11D Blaster Code

Please select which code you require in Available Options before purchase

Arduino Pin Configuration:

WS2812B LED Strip and Fire LED Data Line to Arduino Pin D3
0.91" OLED Display Screen SDA to Arduino Pin A4 - SDA
0.91" OLED Display Screen SCL to Arduino Pin A5 - SCL
Trigger Button/Switch One Pin Arduino Pin D9
Weapon Select Button/Switch One Pin to Arduino Pin D8
Reload Button/Switch One Pin to Arduino Pin D7
Scope On-Off Button/Switch One Pin to Arduino Pin D5
Scope Power Connector POS to Arduino Pin D4
DFPlayer Mini RX to Arduino Pin D1 - TX 

F-11D ONLY

Flashlight On-Off Button/Switch One Pin to Arduino Pin D6
Flashlight LED Connector POS to Arduino Pin D2

All switch/buttons have a GND wire going from the same button pin used to connect to the Arduino with a 10K Ω resistor.
The other switch/button pin goes to POS.
The WS2812B LED strip POS goes direct to the battery - GND to GND
All other POS and GND connections go to 5V POS and GND on the Arduino

The same Pin Numbers are used for either the Arduino Nano or Arduino Pro Mini. 

Please Note: No other Arduino Nano Digital or Analogue Pins are configured on the BLTroniX V2.0 PCB Board.

Arduino Pin Configuration:

• E-11/F-11D Blaster - https://www.proptronix.co.uk/image

Package Includes:

• 1 x BLTroniX Arduino Nano V3.0 + Blaster Code

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy