E-11 Stormtrooper Blaster Rifle Electronics Kit. 

This kit is available as either a self build or as a pre-built electronics kit for the Star Wars E-11 Stormtrooper Blaster Rifle.

Self Build Kit - Some soldering is required to solder the wires to the switches, OLED display and WS2812B Neopixel's.

Pre-Built Kit - Some wires may need to be cut and shortened to fit inside your Blaster Build so some soldering may be required.

I recommend using 30awg silicone wire for connecting all switches as this wire is thin and very flexible.

The BLTroniX E-11 Stormtrooper Blaster Rifle Electronics Kit includes the following components:

• BLTroniX PCB Board with all resistors, sockets and headers pre-soldered.
• Arduino Pro Mini Micro Controller pre-programmed with the BLTroniX E-11 Stormtrooper Blaster Rifle Code
• DFPlayer Mini MP3 Player 
• Micro SD-Card with Sounds Pre-Loaded
  
• PAM8403 Amplifier
• 3W 4Ohm Speaker
• 0.91" OLED Display (Choice of Screen Display Colour, White, Yellow or Blue)
• Double Sided Sticky Pad - To hold the 0.91" OLED in place in the Hengstler Counter
• Micro Lever Switch - Trigger
• 6 x 6mm Momentary Tactile Switch x 2 - Weapon Select and Scope On/Off 
• 6 x 4mm Momentary Tactile Switch - Weapon Reload
• Single WS2812B LED (Fire LED)
• Strip of 17 WS2912B LEDs (Barrel LEDs)
• 4 Pin JST PH 2.0 Lead for the OLED Display
• 3 Pin JST PH 2.0 Lead for the LED Strip & Fire LED
• 2 Pin JST PH 2.0 Leads x 6 for Trigger, Weapon Select, Weapon Reload, Scope Power, Scope On/Off & Battery
• TP4056 Battery Charge Board
• 1 x PropTroniX 18650 Battery Holder  - For the Battery
• Mini On\Off Slide Switch

Don't forget to add the following products to your order:

E-11 Stormtrooper Blaster Rifle STL Files:

These STL Files were designed by me especially for my E-11 Blaster Electronics

E-11 Stormtrooper Blaster Rifle Scope Electronics Add-On Kit:

The add-on Scope Electronics kit includes the components to add an animated scope display to your BLTroniX E-11 Stormtrooper Blaster.

E-11 Stormtrooper Blaster Rifle STL Hardware Kit:

The E-11 Blaster STL Hardware kit includes all the screws and springs used in the build.

Please Note: This kit does NOT include a battery. 

Due to postal restrictions regarding the shipping batteries I am unable to include them in the kits.

I recommend using a 3.7V 18650 protected cell battery, 

These are readily available on eBay and Amazon.

Very Important Notice:

Please make sure you double check the polarity of all connections before attaching any power.

Package Includes:

• 1 x E-11 Stormtrooper Blaster Rifle Electronics Kit

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy