Description
Reviews (0)

E-11 BLTroniX PCB V2.0

E-11 Blaster Electronics PCB Board

The BLTroniX V2.0 Blaster PCB board comes with all resistors soldered in place and fully tested.

E-11 Blaster Board PCB dimensions - 24mm W x 123mm L - Please make sure this will fit inside you blaster

This board is longer then the V1.0 PCB but is only 24mm Wide so will fit inside most Blasters.

It is designed to be used with an Arduino Nano V3.0 programmed with my BLTroniX V2.0 Code for the E-11 Blaster

FREE - E-11 BLASTER ARDUINO CODE - FREE

This PCB will also work with my FREE E-11 Blaster Code which is available on GitHub

You can use the SCOPE POWER Connector as the Laser LED Power and the SCOPE SWITCH Connector for the Laser LED On/Off Switch.

It does NOT allow you to use the Magazine Detection Switch so use the code - Arduino-E-11-V1.0-NO_MAG

If you want to incorporate the Magazine Detection Switch and use that code you will have to wire the Magnetic Reed Switch directly to the Arduino Nano Pin D6, +5V and GND with a 10K Resistor.

The PCB has Connections for:

Trigger Button
Weapon Select Button
Weapon Reload Button
Barrel LED Strip and Fire LED
0.91" OLED Display (Optional)
Scope On/Off Button
Scope Power
2 x Speakers (2nd speaker is Optional)

You will need to purchase the Arduino Nano and all other components separately to complete your Blaster.

Package Includes:

1 x E-11 Blaster Electronics PCB V2.0

Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

Before placing your order, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy